Pny P-DSA150-PCI-RF Manual de usuario

PCI SATA RAID 2 CH. (2 External/ 2 Internal) CARD User Manual Model P-DSA150-PCI-RF Ver. 1.0 All brand n

Aug/07 MN2036400000 103. At the next screen select Mirrored then press Enter. 4. Select Manual configuration,

Aug/07 MN2036400000 11Rebuilding a Failed Mirror Set When a failure to one member occurs, you will be notified e

Aug/07 MN2036400000 124. When asked Are You Sure(Y/N)?, press Y to confirm. Resolving Conflicts When a RAID se

Aug/07 MN2036400000 13follow the section “Rebuilding a Failed Mirror Set” to rebuild the mirror. Low Level Form

Aug/07 MN2036400000 14blank floppy disk then follow the directions below. 1. Setup the RAID Array prior to Wind

Aug/07 MN2036400000 155. If the Digital Signature Not Found message appears, click Ye s. Our driver has been th

Aug/07 MN2036400000 16Note: If the Security Alert warning pops up, click Ye s. Our driver has passed Microsoft c

Aug/07 MN2036400000 173. Restart the computer when prompted by Windows’ installation. 4. At the Windows Setup

For Windows® Vista For New Installation A new installation requires a floppy disk for the driver installation. To make this floppy disk, copy the con

Aug/07 MN2036400000 19 For Windows® Vista-x64 For New Installation A new installation requires a floppy disk fo

Aug/07 MN2036400000 2Features and Benefits z Connect a maximum of 2 SATA hard drives to any of the 4 connecto

Aug/07 MN2036400000 205. Insert the floppy disk, please select Silicon Image SiI 3512 SATARaid Controller (A:\s

Aug/07 MN2036400000 21Image SiI 3512 SATARaid Controller to display driver properties. A message this device is

Aug/07 MN2036400000 22(Change D: to match your CD-ROM drive letter) 4. Follow the on-screen instructions to com

Aug/07 MN2036400000 3System Requirements z One available PCI slot z Windows® 2000, XP, Server 2003 and Vista

Hardware Description Aug/07 MN2036400000 4Jumper Jumper Settings Active Port J8 J7 J6 J5 Internal SATA Port B

J8 J7 J6 J5 External SATA Port D Enabled (Con4) J4 J3 J2 J1 Internal SATA Port A Enabled (Con1) J4 J3 J2 J1 External SATA Port C Enabled (Con3)

Aug/07 MN2036400000 6Hardware Installation 1. Turn Off the power to your computer and any other connected perip

Aug/07 MN2036400000 75. Follow the same instructions to connect up to two hard drives. Device connection is now

Aug/07 MN2036400000 85. When asked Are You Sure (Y/N)?, press Y to accept. 6. Press Ctrl+E to exit the BIOS. 7

Aug/07 MN2036400000 911. Continue with steps outlined in Appendix A for formatting your hard disk drive. RAID